DIGIPILOT 5510 Acknowledgement device for manual work optical and acoustical notification

• Features

  • Variably adjustable optical and acoustical signalling of OK/NOK parts
  • Processor controlled device, up to 8 different operation modes selectable
  • OK/NOK lamp on the front side
  • External interlocking, operation and display
  • Robust housing for industrial environment front plate IP65
  • Usable on desktop or installed to panel meter

• Product data

  Model	5510
  Supply voltage	90 ... 264 Veff / 47 ... 63 Hz
  Protection class	Front panel: IP65 Housing: IP30
  Range of operating temperature	+5 ... +40 °C
  Specific characteristics	Variably adjustable optical and acoustical signalling of OK/NOK parts Processor controlled device, up to 8 different operation modes selectable OK/NOK lamp on the front side External interlocking, operation and display Robust housing for industrial environment front plate IP65 Usable on desktop or installed to panel meter

• Description

  On production floor, the need for optical as well as acoustical notification of OK and NOK parts can be found oftentimes next to the evaluation done by measuring and evaluating instrumentation. Especially for manual work places with a certain allowed time/work piece ratio the additional notification related to the product is wanted, sometimes also the control of the previously identified OK and NOK parts. This function is fulfilled by DIGIPILOT 5510.

  The control device regulates dependencies of work processes by necessary acknowledgement of OK- and/or NOK parts and informs the results visually via warning lamp and acoustically via buzzer. Moreover, the mechanical arrest of a press, storing area or part feeding can be effected until an unmistakable identification for the product is done.

  The dependencies of acknowledgement, alarm and arrest are determined by the different operation modes which can be changed only by the fitter himself. The 24 V supply voltage for supplying the inputs "OK-" and "NOK acknowledg ments" is available even without a connected PLC. The DIGIPILOT 5510 is designed for rough industrial environment. As a complete unit with different switching and notification possibilities the device is priced at good value compared to a collection of separate solutions.

  DIGIPILOT 5510 is optimized to collaborate with DIGIFORCE^® 9310. The two devices are connected electrically 1:1 via the PLC interface of DIGIFORCE^® 9310 and a 25 pin cable model 9900-K331. If DIGIFORCE^® 9310 is controlled via PLC the connection must be done on the available second bushing on DIGIPILOT 5510. DIGIPILOT 5510 offers different operation modes that need to be activated by jumpers in the 15 pin Sub-min-D connector for both modes, active as well as passive, i.e. with or without acknowledgement.

  This acknowledgement can be effected via the warning lamp on the front side of the instrument or via an external button (normally open). At the beginning of a new measurement, the present evaluation is erased. In the operation mode "Confirmation and evaluation NOK" the red light stays switched-on, even at a new measurement start. It will switchoff only after acknowledging the "NOK" result by pushing the green button.

• Data Sheet & Downloads

  Data sheet

  5510

  DEEN

  Operation manual

  5510

  DE

  Brochure

  100 % press-fit control at manual workstations

  DEEN

  Further info

  Simple retrofitting for hand lever presses

  DE

• LINKS & CAD DATA

  CAD data model 5510

  CAD data accessories for measuring instruments

Related products

8451, 8552

8712, 8713

DIGIFORCE® 9311

DIGIFORCE® 9307

5501