Highly accurate, very low mounting height, simple force introduction, for tension and compression, for static and dynamic measurement, material aluminium resp. stainless steel, protection class IP 54
Please notice that there is a limit of 5 products for the product comparison.
Your latest selection was canceled.
×
Model | 8511 |
Measuring range |
0 … 5 N |
Direction of force | Tension and compression |
Standardization | Option |
Signal output |
1 mV/V |
Protection class | IP54 |
Overload protection | Option |
Range of operating temperature | -30 ... +90 °C |
Specific characteristics |
|
The measuring element of the load cell consists of a double bending beam on which strain gages are applied. The applied force detunes the measuring bridge so that a proportional output voltage is generated. The strain gages on the measuring element are protected against dirt and water spray by a rubber bellows.
The sensor can be easily mounted via two mounting holes. The tension or compression force to be measured is introduced at the opposite end perpendicular to the sensor axis.
Due to its special design, the influence by an extension (e.g. touch finger) on the measuring signal is low. Overload protection can be realized with little effort using a mechanical stop.
Example showing tightly-packed assembly of bending-beam load cells with overload protection
Talstr. 1-5
76593 Gernsbach
Germany
Fon: +49 7224645-0
Fax: +49 7224645-88
infoburster.com
www.burster.com
Wire
15.04. -
19.04.24 -
Düsseldorf,
40474,
Germany
The Battery Show
18.06. -
20.06.24 -
Stuttgart,
70269,
Deutschland
burster gmbh & co kg
sensors & precision measurement
Talstr. 1-5
76593 Gernsbach
GERMANY
Contact:
Phone: (+49) 07224-6450
Fax: (+49) 07224-64588
E-Mail:
infoburster.de
The measurement solution.
It‘s with this ambition and for over half a century burster, a global player in the precision measurement technology industry, supplies some of the world’s most recognizable brands with sensors, precision measuring devices and measuring systems for sensor signaling processing. This is all done through our research, development and production headquarters in Germany.
Where quality assurance and production control play a significant role, burster is on board.