Non-rotating tightening-torque measurement

on electric screwdrivers

  • Extremly low profile
  • Bending moments have little impact on measurement quality
  • Standard square shaft
  • Excellent value for money
  • Suitable for use in harsh conditions thanks to ultra-rugged sensor design

Task

In a simple test station for electric screwdrivers, an 8632 nonrotating torque sensor is used to measure the screw tightening torque M4 to M6 screw connections.

Specific requirement

Einfache Integration des Sensors in manuellen Prüfplatz. 

Solutions

This is done by embedding the torque sensor in a C-section mount: the external square shaft is inserted into the base plate and held so it cannot rotate, while the sensor body is fixed and aligned in the C-section itself. The various screw sizes are screwed into specially made fixtures, and the maximum tightening torque is measured. The aim is to optimize the torque set in the electric screwdriver to avoid overtightening screws, to optimize downtimes, etc. 

Go to product 8630

Sectors

burster in Malta

Malta

burster Italia S.r.l.

Via Repubblica, 10
24035 Curno
Italy

Fon: +309 035 618120
Fax: +39 035618250
infoburster.it
www.burster.it

SERVICES

  • Qualified design, application support
  • Process optimization
  • Qualified integration support & training
  • On-site trouble shooting
  • Qualified phone & online support
  • Local calibration service
×

Product Inquiry

    Product comparison

      Brandnew Brochure: Load cells

      Discover our new brochure Load cells for production, automation, R&D and quality assurance with many application examples and product focused information!

      Download our new brochure

      © 2024 // burster Italia s.r.l.
      nach oben