8303 Trasduttore di pressione

• Features

  • Range di misura da 0 ... ± 50 mbar a 0 ... ± 10 bar
  • Precisione < 0.5 %
  • Elevata pressione di linea
  • Per sostanze liquide e gassose
  • Amplificatore di misura integrato

• Product data

  Model	8303
  Measuring range	0 … ± 50 mbar 0 … ± 100 mbar 0 … ± 200 mbar 0 … ± 500 mbar 0 … ± 1 bar 0 … ± 2 bar 0 … ± 5 bar 0 … ± 10 bar
  Kind of measurement	Differential pressure measurements in both directions
  Line pressure	Max. 100 bar
  Signal output	4…20 mA 0…20 mA 0…5 V
  Range of operating temperature	-25 ... +85 °C
  Max. overload for one side	Three times measuring range
  Burst pressure/ -protection	300 % over capacity
  Dead volume	Both sides 0.35 cm3
  Specific characteristics	High line pressure For liquid or gaseous media Integrated measurement amplifier

• Description

  The pressure transmitter illustrated here measures differences in pressure between the two connections of the measuring element. Pressure differences can be measured with respect to a reference pressure, such as atmosphere, or to the command variable of a regulation system. Equally, however, it is possible to measure pressure differences within systems that have a high static pressure. One practical example of this would be measuring a flow rate by determining the pressure drop occurring across a metering diaphragm. 

  The differential pressure transmitter measures in both directions and can therefore, for instance, be used on double-acting hydraulic cylinders. Its construction permits it to be used with liquid or gaseous media. Venting holes simplify installation. The robust design and the use of stainless steel make it possible to use the pressure transmitter under tough operating conditions. 

  It is fitted with integrated electronics to make the pressure transmitter even easier to use. This delivers the usual  current or voltage outputs familiar in measurement and control engineering.

  The differential pressure transmitter has a chamber on each pressure port. The chambers are separated by a diaphragm. Coils are located, and hermetically sealed, within the two halves of the sensor housing on both sides of the diaphragm. If there is a difference in the pressures on the two sides of the center element, the diaphragm is deflected from its rest position. As a result, the reluctance of the two coils, which are wired as differential inductances, changes. The integrated electronics converts the changed inductance ratio into the desired output signals, which are then available for further processing.

• Data Sheet & Downloads

  Data sheet

  8303

  DEEN

Related products

9180

SENSORMASTER 9163

9206